Nissan Rogue Service Manual: S connector circuit

Nissan Rogue Service Manual: S connector circuit

Description

The starter motor magnetic switch is supplied with power when the ignition switch is turned to the START position while the selector lever is in the P (Park) or N (Neutral) position.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to STR-7, "Wiring Diagram".

CAUTION: Perform diagnosis under the condition that engine cannot start by the following procedure.

  1.  Remove fuel pump fuse.
  2.  Crank or start the engine (where possible) until the fuel pressure is released.

1.CHECK “S” CONNECTOR CIRCUIT

  1.  Turn ignition switch OFF.
  2.  Disconnect starter motor connector.
  3.  Shift selector lever to “P” (Park) or “N” (Neutral) position.
  4.  Check voltage between starter motor harness connector and ground.

Check “S” connector circuit

Is the inspection result normal? YES >> “S” circuit is OK. Further inspection is necessary. Refer to STR-11, "Work Flow (With GR8-1200 NI)" or STR-15, "Work Flow (Without GR8-1200 NI)".

NO >> GO TO 2.

2.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

  1.  Disconnect IPDM E/R connector.
  2.  Check continuity between starter motor harness connector and the IPDM E/R harness connector

Check harness continuity (open circuit)

  1. Check continuity between starter motor terminal S and ground.

Check harness continuity (open circuit)

Is the inspection result normal? YES >> Further inspection is necessary. Refer to STR-11, "Work Flow (With GR8-1200 NI)" or STR-15, "Work Flow (Without GR8-1200 NI)".

NO >> Repair or replace the harness or connectors.

Symptom diagnosis

STARTING SYSTEM

Symptom Table

Symptom Reference
No normal cranking Refer to STR-11, "Work Flow (With GR8-1200 NI)" or STR-15,  "Work Flow (Without GR8-1200 NI)".
Starter motor does not rotate
B terminal circuit
Description Terminal “B” is constantly supplied with battery power. Diagnosis Procedure Regarding Wiring Diagram information, refer to STR-7, "Wiring Diagram". CAUTION: Perform diag ...
Removal and installation
STARTER MOTOR Exploded View REMOVAL Transaxle assembly Starter motor Lower bolt  Upper bolt Removal and Installation REMOVAL  Remove battery tray. Refer to PG-77, & ...
Other materials:

Heater operation
Heating This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and the side vent outlets.  Press the button to change to fresh air intake mode.

Related news

  • Kia Forte: DCDC Converter Description
  • Toyota Camry: Tire inflation pressure
  • Toyota RAV4 Service Manual: Dtc check clear
  • BMW 5 Series: At a glance
  • Buick Regal: Engine Oil Pressure Light

  • Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit

    Nissan Rogue Service Manual: S connector circuit