Mazda 3 Service Manual: Splash Shield Removal/Installation
Inboard Light Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the trunk lid trim.. 3. Disconnect the connector. 4. Remove the nut. 5. Remove the bracket. 6. Remove the inboard light as shown in the figure. 7. Install in the reverse order of removal.. 5HB 1. Disconnect the negative ...
Sunroof Motor Inspection
1. Disconnect the negative battery cable.. 2. Remove the rain sensor cover. (Vehicles with auto light/wiper system). 3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system) 4. Partially peel back the seaming welts. 5. Remove the following parts: a. Sunroof seaming ...
Chart symbols: I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if necessary. R: Replace L : Lubricate C: Clean T: Tighten Remarks: *1 Use of FL-22 is recommended when replacing engine coolant.