Chevrolet Cruze Repair Manual: Luggage Compartment Description and Operation
Rear Compartment Lid Release System Components
- Body control module (BCM)
- Exterior rear compartment lid release switch
- Rear compartment lid release actuator
- Rear compartment lid release relay
Rear Compartment Lid Release Operation
When the exterior rear compartment lid release switch is pressed, the trunk release switch signal circuit is switched to ground. The BCM responds by applying battery voltage to the trunk release relay control circuit which energizes the rear compartment lid release relay. The rear compartment lid release relay is supplied with battery voltage at all times from an instrument panel fuse. With the relay coil energized, the relay switch contacts close allowing battery voltage to flow to the rear compartment lid release actuator causing the rear compartment lid to release. The exterior rear compartment lid release switch is permanently grounded to a fixed body ground.
When accessing the rear compartment using the key fob, a valid keyless entry transmitter is required to be within a 30 meter range of the vehicle. This allows the required keyless access communications to occur between the rear compartment antenna and the keyless entry transmitter. For more information about keyless access, refer to Keyless Entry System Description and Operation.
Rear Side Door Window Adjustment
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Warning: Refer to Express Window Down Warning in the Preface section. Preliminary Procedures Remove the rear side door trim. Refer to Rear Side Door Trim Replacement. Remove the water deflector. ...
This information provides repair recommendations and general guidelines for steel classified as Mild Steel. This type of steel normally has a tensile strength less than 270 MPa.